Skip to content

First-Time Setup

When you open the Gateway in a browser for the first time, it will take you through a short setup wizard, headed Welcome to OnVeris. The wizard registers your licence and creates the first administrator account. The steps along the top show where you are. Steps that are not needed on your machine will be skipped.

Step 1 — Accept The Licence Agreement

Read the End User License Agreement and click Accept to continue.

Step 2 — Register This Gateway

Enter the Serial Key you received when you bought OnVeris, and click Next. The Gateway will contact Parker Software to activate your licence, so it needs internet access for this step.

Without Internet Access

If this machine cannot reach the internet, click Offline Registration. The Register without internet access window will open:

  1. Send us this activation request — copy all of the request shown, including any line breaks, and email it to Parker Software. A licence is tied to one machine, so one cannot be issued until you send this.
  2. Paste the licence we send back — when the licence arrives, paste it in and click Install licence.

Step 3 — Verification

The Gateway will check your licence. This happens by itself. If it fails, the message will say why — click Retry, or Back to check the serial key.

Step 4 — Add A User

Create the first administrator account. Enter a First name, Last name, Username, Password and Repeat Password, then click Next.

This account has full access to everything, including users, Nodes, licensing and API Keys. Choose a strong password.

Step 5 — Extra Settings

Automatically connect to nearby nodes — when this is on, the Gateway will find Nodes on your local network and connect to them by itself. Leave it off if you would rather add each Node by hand. You can change this later in Settings → General.

Step 6 — Done

Setup complete! Click Finish and log in with the account you just created.

Next Steps

Once setup is complete, there are a few more things to do before people start using OnVeris:

  1. Check your Node. If you installed the Gateway and Node together, the Gateway will connect to the local Node by itself. Otherwise, add your Node. A Node on another machine needs this Gateway's access key first. See Installing A Node On Another Machine and Managing Nodes.
  2. Add models. See Adding Models.
  3. Set up a trusted certificate, so browsers and the chat apps connect without warnings. See Certificates and Security.
  4. Set up email, so OnVeris can send new users their passwords. See Settings.
  5. Add your users. See Users and Permissions.